Random good picture Not show

1. Tested by UL for 150k cycle test.

2. So this low temperature cycle test is introduced.

3. Responsible for the project life cycle test.

3. Sentencedict.com try its best to collect and build good sentences.

4. After the cycle test, the door shall meet the pull force requirements of section 25.

5. Be responsible for pump rapid cycle test, pump slow cycle test and pump performance test.

6. When the rapid charge was adopted for the cycle test, the battery should be restored to full charge state by the normal charge after a few cycles.

7. Due to long cycle test, data was difficult to obtain in underground-source heat pump system, because the temperature of surface and underground source heat is beyond human control.

8. The causes of frequent failures in duty cycle test of gapped MOA and correct selection of parameters of resistor columns are always topics of concern of manufacturers and users.

9. Thermal cycle test demonstrates that the fatigue life of 3 D - MCM are more than 1500 temperature cycles.

10. Cycle test revealed that inner resistance (IR) of batteries increased gradually with cycling and then suddenly increased after certain cycle.

11. Steer lock instrument was developed for endurance cycle test of the steer lock.

12. Long term immersing Marshall test and frozen-thaw cycle test were used to investigate the anti-stripping performance of andesite asphalt mixture using cement and anti-stripping agent.

13. Moreover, hot-gas cycle test is carried out to simulate the uses in the work field, which can be used to evaluate the heat resistance of the large-scale equipment.

14. The electronic throttle developed is installed on the hybrid electric vehicle (HEV) to conduct vehicle starting test and multi-mode cycle test.

15. When performing testing based on use cases, the most obvious technique is the process cycle test (or algorithm test).

16. By the LLDPE / paper and plastic composite plate wet cycle test, the results show that the board has some certain durability.

17. Through water pressure test, ammonia leakage test and field high temperature melted salt cycle test, it is shown that the tube joint welding quality meets completely the design and process demands.

18. The paper introduces the structure of the battery, aerospace mechanics environment test criteria and simulative cycle test procedures for GEO .

19. Solder joint fatigue life is generally ascertained through accelerated temperature cycle test on electrical subassembly.